Connecting Gateways with BPBX

For the users who newly installed Brekeke latest version PBX, the following ARS rules are needed to receive or send calls with VoIP gateways.

ARS rule setup for a gateway

From Brekeke PBX > [ARS] > [Settings], open ARS template named gw1 or gw2:

Click [Edit Variables] at upper right corner of the template
set variables as below and save the settings
&v1: the dialing number sent from gateway
&v2(password): donot need to set
&v3: BPBX extension to answer the incoming calls from gateway
&v4: BPBX extensions to allow to make outbound calls to gateway
regular expressions can be used here, ex. if you want only BPBX extensions with prefix 1 to make outbound calls, then you can set here as ^1.+$; regular expression ^.+$ means all BPBX extensions
Go back to template, uncheck the [Disable] box at the top of template.
At Pattern - OUT 1, replace [gw1_address] with gateway IP address, then [Save and Update] the settings

Calls with a gateway

The above gateway setup will register gateway to Brekeke PBX bundled SIP Server and use default dial plan named "To PBX From ITSP" to route the incoming calls from gateway to PBX and PBX extension which is set at v3.

For making outbound calls to a gateway, depending on how [Matching patterns] >[To] is defined in Pattern - OUT, you need to dial either prefix before the destination numbers or just destination numbers.

Related links:

Username
Password
Remember me

System message

Connecting Gateways with BPBX

ARS rule setup for a gateway

Calls with a gateway

Connecting Gateways with BPBX

ARS rule setup for a gateway

Calls with a gateway