System message

Set up Brekeke PBX Auto Sync

1. Set up on Primary Server
   At primary PBX, [PBX admintool]>[Options]>[Auto Sync]>[Primary Server Settings], set
   ---------------------------------------------------------
   Remote IP Address Filter: Secondary IP patterns regular expression,
   ---------------------------------------------------------
   e.g. ^192\.168.*$ to allow the connection from IPs begin with 192.168
   Save the settings
   
   
2. Set up on Secondary Server
   
   At secondary PBX, [PBX admintool]>[Options]>[Auto Sync]>[Secondary Server Settings], set
   ----------------------------------------------------------
   URL of Primary Server: http://PRIMARY_IP_ADDRESS:port/pbx
   ----------------------------------------------------------
   on Window, default port: 28080, e.g. http://192.168.200.10:28080/pbx
   on Linux, default port: 8080, e.g. http://192.168.200.10:8080/pbx
   
   Save the settings
   Restart PC of secondary PBX
   
   
3. Test Brekeke PBX Auto Sync
   Changes at the primary Brekeke PBX will be updated on the secondary Brekeke PBX automatically.
   
   The PBX settings, which can be synchronized through Auto Sync, are the following:
   
   • Tenant settings
   • User Settings (voicemail, prompts)
   • System Prompts, Tenant System Prompts
     
   • Notes (System/Tenants)
   • ARS rules

Note: The ARS rule setting changes on primary server will be updated on secondary server. However the enabled ARS rules will not run on secondary server untill failover happens. When failover happens, the enabled ARS rules will run automatically on secondary server, and show running under secondary Brekeke PBX > [ARS] > [Running Status].

• Remove the auto sync settings on the secondary Brekeke PBX
  Save settings and restart PC of secondary server
• Remove or change the auto sync settings on the primary PBX and Save settings
  Brekeke PBX primary server will not send update to previous secondary server.